How To Finish Without Streaks? – Viewer Question
This Viewer Question is from Matt and its a little different than what we usually do. Instead of a simple question and a simple answer, this is an example of a long exchange that eventually leads to an excellent result and a happy ending. As you’ll see, it never hurts to ask questions!
I’m hoping you can help me with a finishing problem I’m having. I have completed a bubinga veneer coffee table, which I’m sure you are familiar with, as it is a David Marks’ design. In the past, I have always had good success with the General Finishes Arm-R-Seal Satin product on much smaller projects/surfaces. However, the large surface (18″ x 44″) of the table top is giving me fits. I can’t seem to produce a finish with this product that is streak or haze free. My technique thus far included:
1. First coat the surface with Seal-A-Cell followed by a light sanding with 320 grit.
2. I apply the Arm-R-Seal with a foam brush, spreading as thin as possible then wiping with a cotton rag, as lightly as possible. All application and wiping is done with the grain. I’ll work an area approximately equal to 1/4 the table top at a time.
3. Inevitably, as I’m about to move to the next section of the top, the wet edges of the previously wiped area are already setting up, making it difficult to blend the wet section back into the previous section.
Read more
Check it Out!
Premium Membership
Keep Up With TWW!
Shop our Affiliates
Latest Video
Proud to be Sponsored By:
Support our Advertisers
