And this was my response:
“You just can’t underestimate the importance of spousal support in something like this. I know far too many people who have to work against the grain just to get a new tool. That doesn’t seem like much fun, lol.”

“As for a sanding sealer, I usually just use shellac. Typically a 1 lb cut. There are two ways to do this. I either buy pre-mixed shellac (Bullseye SealCoat), and dilute it from 2lb cut to 1lb cut. Or I simply but dry shellac flakes and mix my own using denatured alcohol. So its not a true sanding sealer by definition, but it accomplishes the same thing. Oh and just a word about true sanding sealers. In general, they contain material that can interfere with finish adhesion to a small extent. The stuff that makes it easy to sand is the same stuff that can weaken the bond of the finish to the surface. So in general, I stay away from commercial sanding sealers. Shellac on the other hand, provides a great base for just about any finish. Hope that helps.”

I have a table top that I stained with oil based stain and I want to use Endro Precat Lacquer but the directions say that I have to use a pre-cat sealer. Can I use a 1LB cut shellac as a seal coat or do I have to buy the special pre-cat sealer?

And here is my response:
Hey Ron. It is nearly always a safer bet going with the sealer recommended by the manufacturer. But, that doesn’t mean you have to. It also doesn’t mean you will get bad results using shellac as a sealer. Shellac really is like a universal binder. I like to think of it as a “clean slate”. A nice light coat of dewaxed shellac is a suitable sealer coat for pretty much any finish. I have used shellac as a sealer for pre-cat lacquer many times with great results.

Just to be safe, it’s always a good idea when trying some new combination, to test adhesion. Get a sample board, give it the sealer coat, then try the enduro finish. Let it completely dry and test for adhesion. You can do a few things for this. Try scraping it off with your fingernail. Then try putting tape on the surface and see if the top layer comes up when you pull the tape off. If either happens, the finish did not adhere properly and the shellac isn’t a good option for that topcoat. I have yet to see that happen though. Good luck!