Router Climb-Cutting? – Question of the Week
This week’s question comes from Ryan who asks:
I realize this question is probably a complete beginner’s question, but I saw mention to the concept of a “Router Climb-cut”. Please can you explain what is meant by this? Thank you for helping.
And this was my response:
Hey Ryan. Climb-cutting can be a pretty risky procedure and its something you want to exercise extreme caution when doing. I always try to figure out if there is some other solution before resorting to a climb cut. But to understand climb-cutting, we first need to understand the proper way to run the router. In general, we always want to run the router AGAINST the direction of the bit. If you travel WITH the direction of the bit, the router can easily go out of your control. The best example I can think of is a picture frame. The proper direction when routing the outside of the frame is counter clockwise. For the inside of the frame, you should go clockwise. The reason for the change is because the work is being approached from the opposite side of the bit and in order to go against the bit direction, we need to change our feed direction. So if you remember the picture frame example, you should always be able to look at a workpiece and quickly decide the proper routing direction.
Now let’s look at climb-cutting. When you don’t follow the above rules, you are climb-cutting. Its a situation where you are going WITH the direction of the bit, and as a result, it requires careful attention and slight passes. Its really the same concept behind a planer or drum sander. The work is fed into the machine and the blades are cutting against the feed direction. If you reverse the feed direction, you could easily have a wooden missile on your hands. And the same thing goes for climb-cutting. So if its so dangerous, why do we do it? Well, there are some instances where the grain direction of the wood is not cooperating, and a climb cut simply results in a smoother cut with no tearout. In reality, those instances are few and far between for me. But if you have to do it, be sure you are removing the smallest amount of material possible with each pass and your workpiece is securely clamped down, otherwise you’ll have a serious problem on your hands.
Here is a good article by Tom Hintz over at NewWoodworker.com that should give you a few more tips and warnings: Climb Cutting
Good luck Ryan and be safe.
Comments
3 Responses to “Router Climb-Cutting? – Question of the Week”Speak Your Mind and Maybe Win a Prize!
Leave a comment and you could be a winner in our Wood Whisperer Giveaway!And if you want a pic to show with your comment, go get a gravatar!
Check it Out!
Premium Membership
Keep Up With TWW!
Shop our Affiliates
Latest Video
Proud to be Sponsored By:
Support our Advertisers
Hey Marc, really enjoyed your interview with Chris Schwartz.. Met Chris just last month judging at “Showcase”, a woodworking show in Saratoga Springs, NY. Chris is a very well versed and talented woodworker who’s gifted communication skills similar to yours picks up the slack where Norm leaves off. Many accolades to both of you.
Mike
PS: Although a woodworker myself for over 30 years, now more into woodturning due to being able to start and finish a worthy item in a day from nothing more than a piece of fire wood.
Climb cut few and far between? The example of the picture frame is a frequent situation where the router is mans best friend. Another is complex shapes cut out on a band saw and refined with the router. I find that to avoid tear out in the latter situation I have to analyse the grain and do a fair amount of climb cutting every time. Maybe it’s just me.
Sincerely,
RHG
Router direction?? Move the router to the right as long as you are
facing the edge that is being cut.